How to Program Your ZEN37 Wall Remote on Z-Box

With simple and intuitive programming on the Z-Box Hub, it's easy to program the ZEN37 Wall Remote. Choose from scene control (multi-tap) or direct association; simply pick your favorite way to program the ZEN37 and follow the easy steps below!

To program the multi-tap functions on the ZEN37, you can follow the standard block scene creation flow, or you can even program the scene straight from the ZEN37 Wall Remote device menu for a simplified and faster approach.

Direct association is another way to program the ZEN37, which allows you to bypass the hub and have the ZEN37 send direct messages to another Z-Wave device.

You'll need to ensure that you're logged in to the WEB UI with a local connection (same Wi-Fi network as your Z-Box Hub)

To Create the Central Scene from the ZEN37 Wall Remote Device Menu:

1. If not on the Home Menu already, from the sidebar navigation menu of the Z-Box web interface, click on the house icon.

2. Hover over the ZEN37 Wall Remote, then click on the setting gear icon.

3. Click on the Advanced tab.

4. From the Button configuration menu, you can configure actions on the device button by creating dedicated scenes according to your needs. Here is how the buttons on the device are organized:

5. To add an action click on Add Action next to the trigger of your choice.

6. You will be redirected to the New Block Scene general scene settings menu. Provide all required information and click Save to proceed.

7. The trigger will be set as per your selection. If required, you can change the button and trigger selection.

8. To assign an action, drag one of the tiles to the ‘Do the following’ section.

9. Once you are done specifying the action, click Save.

10. You may need to wake the device up for the new automation to take effect:

Click the lower left button 6 times as quickly as possible to wake the device up.
The LED indicator will stay on solid blue during wake-up and will turn off when the device turns the Z-Wave radio off again.

11. To review the scene or to add additional actions, navigate back to the Device Advance Settings section. To edit or edit any of the actions, navigate to Settings/Scenes and select the action/scene that you want to edit.

Click here for general button programming instructions on the Z-Box Hub, including screenshots and examples.

To Set Up Direct Association from the ZEN34 Remote Switch Device Menu:

1. If not on the Home Menu already, from the sidebar navigation menu of the Z-Box web interface, click on the house icon.

2. Hover over the ZEN37 Wall Remote device, then click on the setting gear icon.

3. Click on the Associations tab.

4. Choose the association group for the button you want to use and its functionality (on/off or dimming control):

Group 2: Basic for on (button 1: top large button) and off (button 2: bottom large button)
Group 3: Basic for on (button 3: small left button) and off (button 4: small right button)
Group 4: Multilevel start level change (held) and stop level change (released) for buttons 1 and 2 (used for remote dimming)
Group 5: Multilevel start level change (held) and stop level change (released) for buttons 3 and 4 (used for remote dimming)
Group 6: Basic to toggle device on and off in sequence when button 1 is pressed
Group 7: Basic to toggle device on and off in sequence when button 2 is pressed
Group 8: Basic to toggle device on and off in sequence when button 3 is pressed
Group 9: Basic to toggle device on and off in sequence when button 4 is pressed

5. Select your target device and click the + symbol. Once done, please manually wake the ZEN37 up to receive the changes, then hit Save.

Please don't hesitate to reach out to us with any questions!