This is product is discontinued and replaced with ZSE70.
Here is a full list of advanced settings (parameters) for the ZSE29 VER. 2.0 (firmware 2.0):
Basic Set Report Value Sent to Associated Devices
Parameter 1: Set the value of basic set report sent to the light associated with the sensor in Group 2 (so the light turns on to the selected brightness level). 99 is the equivalent of full brightness in Z-Wave terms.
Values: 0 – 99. Default: 99.
Size: 1 byte dec
Enable / Disable Motion Reports
Parameter 2: Enable or disable motion reports completely. If motion sensor is disabled, the device will not report motion at all to your hub.
Values: 0 – motion reports disabled; 1 – motion reports enabled (default).
Size: 1 byte dec
Motion Sensitivity
Parameter 3: Set motion sensitivity for the motion detector to minimize false alerts.
Values: 1 – 10 where 10 is the most sensitive and 1 is the least sensitive.
Size: 1 byte dec
Lux Level Trigger
Parameter 4: Set the lux level trigger. If brightness level is lower than the set lux value, the sensor will send a motion event notification to the hub and a basic set report devices associated in Group 2.
Values: 0 – lux trigger set manually at the lux knob; 1 – lux trigger ignored, every motion event is reported; 10 – 900 (lux). Default: 0.
Size: 2 byte dec
Parameter 8: READ ONLY. Read the values for the lux trigger knob set physically at the sensor.
Values: 10; 50; 100; 200; 300; 900 lux (at T position / test mode).
Size: 2 byte dec
Parameter 6: Set the reporting frequency for the light sensor.
Values: 1 – 1440 (minutes). Default: 30.
Size: 2 byte dec
Motion Clear Time
Parameter 5: Set the amount of time the sensor will wait before reporting no motion after the last recorded activity.
Values: 0 – set manually at the timer knob; 5 – 720 seconds (add 5 seconds to entered value so if value is set to 10, the actual clear time is 15 seconds, etc). Default: 0.
Size: 2 byte dec
Parameter 7: READ ONLY. Read the values for the timer (motion clear) knob set physically at the sensor.
Values: 5 (at T position / test mode); 30; 60; 300; 600; 720 (seconds).
Size: 2 byte dec
How to Access the Advanced Settings:
If you have any questions about adjusting advanced settings in your hub, please get in touch. We introduced many new settings with VER. 2.0 of the sensor which required a hardware update as well so unfortunately a VER. 1.0 sensor cannot be upgraded to 2.0 through an OTA firmware update. The ZSE29 Outdoor Motion Sensor can be updated via OTA firmware updates within the same hardware version, here is how to do that. You can access all firmware files here after you register your product and create an account here. Questions? Just reach out to our tech support team.
