The ZEN16 Multirelay is officially integrated with Hubitat and will work out of the box.
You will have full access to the device's advanced settings directly from the device view on Hubitat. If you don't see them, confirm your Hubitat platform is up-to-date on the latest version and then install the community driver. Then, you can just follow the step-by-step instructions below to add your ZEN16 Multirelay to your hub. The process shouldn't take more than 5 minutes:
Smart Start Inclusion
On the Hubitat app:
- Open the Tools tab (wrench icon on the bottom)
- Scroll to the bottom, select Z-Wave
- This will take you to a screen where you can select either Smart Start or regular inclusion
- Select Smart Start
- This will take you to the smart start inclusion list. Devices will be displayed there that are in the process of inclusion through Smart Start.
- Select the QR symbol in the top right to open the camera for the DSK scan (Scan the QR code printed on the device.)
- Power the device (important to do this AFTER QR scan
- The device integration will begin. The window will appear asking you to name the device; click Save after naming
- Finishing inclusion may take a few minutes
If you have any issues with Smart Start Inclusion on Hubitat, please review this video: https://www.youtube.com/watch?v=Sf-Fldjb0to. The steps should be the same whether you have a C-7 or C-8.
Manual Inclusion
- Open Hubitat in your Internet browser
- Go to Devices
- Click on + Add Device in the top right corner
- Click on Z-Wave
- Click on Start Z-Wave Inclusion
- While the app says is in inclusion mode, click the Z-Wave button on the device 3 times as quickly as possible (LED indicator will start flashing)
- Rename and confirm the found device
NOTE: You’ll most likely see 4 new on/off devices in your app:
- 3 channels for on/off control of each relay
- 1 master node to control all relays at the same time and to access and adjust advanced settings in (if your hub supports parameter input)
If you're having issues with adding the relay correctly to your hub, try excluding the device using the steps shown here before trying to add the relay again. Exclusion acts as a reset and it can help with a variety of configuration issues.
If exclusion doesn't help, reach out to us for assistance.
