Exclude to include? You would be surprised what might work to connect your ZEN05 Outdoor Smart Plug to your hub.

Exclusion is another name for a soft reset, which helps to fix various connectivity and configuration issues. It can even be done if the device has never paired successfully to any hub. Once Hubitat confirms that an "unknown" device was excluded, you’ll be able to try to add it to your network again. Ensure you are running the latest platform version of Hubitat.

ZEN05 Exclusion Steps

1. Open Hubitat in your Internet browser

2. Go to Devices

3. Click on + Add Device in the top right corner

4. Click on Z-Wave

5. Click on Start Z-Wave Exclusion

6. While the device is searching for a device, click the Z-Wave button on the device 3 times as quickly as possible

7. The app will indicate when the device is successfully excluded.

Once you’ve gone through the exclusion process, give inclusion another try.

SmartStart and Z-Wave Long Range Inclusion Troubleshooting

If exclusion is not successful, if you have previously added this device to your hub, if SmartStart failed, or if the device will not include, please follow the steps below in order. Removing the device from the provisioning list generally resolves most inclusion issues:

Removal of a Z-Wave Plus SmartStart device is a two step process. First remove the device from the app, then factory reset it.

1. Using the Hubitat Elevation mobile app, navigate to Tools and press the Z-Wave Tools card

2. Tap the SmartStart button > Tap the trash can icon to remove a device from the provisioning list. Removing an item from the SmartStart provisioning list does not remove it from the hub. You must also factory reset it, so it will no longer be part of the Z-Wave network. 

   • NOTE: Any device that has been removed from the provisioning list, but has not been factory reset or excluded from the Z-Wave network, will be automatically included again if it has power, and it will repopulate the provisioning list showing the Included status.

  3. The device has now been removed from the provisioning list.

  4. Factory reset the ZEN05. After a successful reset, the device will disappear from the device list.

  5. Remove the ZEN05 from power if you plan to include the unit via SmartStart / Z-Wave Long Range. 

  6. Go through the inclusion steps listed here to include the device (remember, power stays OFF until indicated).

Additional Troubleshooting

• Try the exclusion process again in case the command from the first run weren't registered correctly. 

• Try bringing the hub closer to the device to see if it connects in a closer location. If it connects without issue in the new spot, then the first location may be out of range or there may be too many interferences in that area.

• And if you find that your device is connected but it's not responded to remote commands, check out these tips for troubleshooting connectivity. 

If you've tried all the above with no luck, let us know! Our team is ready to help.