Inclusion is fast and easy with the Z-Box! You don't need any extra device handlers or drivers here! The ZEN55 Smoke & CO Detector Bridge will be recognized correctly on the Z-Box, as it is fully integrated. Simply follow the instructions in the manual to install and power the device, then follow the steps below to add the device to your Z-Box hub. You can add a new device via the web interface, or the mobile app. Check out the simple inclusion instructions below!
Important Note: A steady, blinking green is the standard state for the device; as long as the unit has power, it will blink green at a steady pace. The device has an internal relay, which can turn on and off with a click of the Z-Wave button. This means that when you are attempting to include or exclude the device, the clicks need to happen as fast as possible; if the clicks are not completed fast enough, the relay will engage instead and the device will not enter inclusion or exclusion mode. You will know you have clicked fast enough when the LED indicator begins flashing rapidly.
Follow the steps below to add the ZEN55 from the Z-Box web interface:
- From the sidebar navigation menu of the Z-Box web interface, go to Settings by clicking on the gear icon.
- You will be redirected to the Devices menu.
- Click on + Add device.
- Select the Z-Wave Device option.
- Be prepared to start inclusion on the ZEN55. Click Start.
- While the hub is in inclusion mode, click the Z-Wave button on the ZEN55 3 times as quickly as possible (the LED indicator will start flashing).
- Enter the 5-digit DSK code (on the back of the ZEN55) when prompted.
- Once the device is detected successfully, you will see the list of all child devices that have been detected. Click Next.
- Rename your device and assign it to a room. Click Next.
- Click Finish once done editing all devices.
How to add the ZEN55 from the Z-Box Hub mobile app
- Open the Z-Box Hub app on your mobile device.
- Click More in the bottom navigation menu.
- Click on + Add Devices.
- Click on Z-Wave Protocol and follow the same inclusion steps as described for the WEB UI above.
Unable to include your ZEN55 Smoke & CO Detector Bridge to the Z-Box? Please follow the steps here to try excluding the device first.
Please let us know if you have any questions; we're always happy to help!
