Use the custom driver below to ensure you can access the advanced settings and complete set up of your ZEN55 Smoke & CO Detector Bridge.
Start by ensuring your hub is operating on the latest Hubitat platform version before installing the driver. Then follow these step-by-step instructions to install the custom driver for the ZEN55:
-
Open Hubitat in your browser.
-
Click on Drivers Code in the side menu.
-
In the top right corner, click on "+New Driver" and paste the code from the following link to access the code for the driver, then copy ALL of the code from the page.
-
Click Save in the top right corner.
-
You'll see a Zooz ZEN55 Double Relay Advanced in your Drivers Code list now.
-
Assign the driver to the device by opening to the device view and selecting the Zooz ZEN55 DC Signal Sensor Advanced from the drop-down menu under Device Type > User.
-
IMPORTANT: Click the Configure button and refresh the page in your browser for all of the settings to display.
-
Adjust all of the settings as needed.
-
Click Update Device.
If you prefer not to use the custom driver, you can try out this Z-Wave Universal Device Scanner to access any parameters that may not be available yet in the custom driver. Please note that use of this driver is intended for expert users; use at your own risk: https://community.hubitat.com/t/release-z-wave-universal-device-scanner/97912
Let us know if you have any questions!
