Here is a list of the changes and updates we made to the ZEN53 DC Motor Controller so far.

VER. 1.0 (released 2/2023)

Original release.
Hardware:

• 700 Series Z-Wave chip
• Pigtail wires for easy installation

Firmware: 1.10

• Works in shutter or Venetian mode

• Z-Wave Long Range ready

• SmartStart for easy and secure inclusion

Firmware 1.20 (released 04/2023 as OTA)

• Fixed direct association behavior. The device now sends the same direct commands for multilevel start-level change commands to devices in Group 4.
• Fixed LED indicator behavior when the device is not connected to a Z-Wave network.
• Fixed momentary switch behavior; it no longer operates the motor in the opposite direction to what is described in the documentation

Firmware 1.30 (released 09/2023 as OTA)

• Improved Auto Calibration mode for certain motors
• Fixed a bug where ZEN53 did not follow the values set in parameter 1 after power failure. 
• Fixed a bug where ZEN53 entered a calibration mode via parameter 5 (value 1 or 2) and did not revert to value 0 – Exit Calibration mode. Reconfiguration or re-interview may be needed after calibration to view that parameter 5 returns to default value 0.

Firmware 1.40 (released 01/2024 as OTA)

• Added Parameter 19: Timer for the motor open/up operation. See all settings here.
• Added Parameter 20: Timer for the motor close/down operation. See all settings here. 

Your DC Motor Controller can be updated via OTA firmware updates, you can access all firmware files here once you register your product and create an account here. Questions? Just reach out to our support!