How to Add Your ZEN76 S2 Switch to the Z-Box Hub

Add your switch to the Z-Box Hub and take advantage of all of its basing and advanced features without any extra steps. Simply follow the steps below to set your new device up in no time!

It's always best to use the WEB UI when including any new Z-Wave devices into your system. But if you rather use the app, just scroll down for additional instructions.

ADD THE ZEN76 SWITCH FROM THE WEB UI:

1. Open your Z-Box web interface in the Internet browser and select Settings (the gear icon) from the sidebar navigation menu.

2. The screen will display all of your existing devices.

3. Click on the + Add device blue button in the top right corner.

4. Select Z-Wave Device in the next screen.

5. Make sure you can physically access your ZEN76 switch and click Start on the screen.

6. While the hub is in inclusion mode, tap the top paddle on the ZEN76 switch 3 times as quickly as possible. The LED indicator will start blinking. It may take a few minutes for the device to add and configure so please wait patiently and don't exit the screen.

7. Once the device is found, you'll be able to rename it and assign it to its room. The ZEN76 switch will create one device for on/off operation and one remote control device for scene control (multi-tap) programming. Click Next and then Finish once you rename and organize all of the newly created devices.

ADD THE ZEN76 SWITCH FROM THE Z-BOX MOBILE APP:

1. Open the Z-Box Hub app on your mobile device.

2. Click More in the bottom navigation menu.

3. Click on + Add Devices.

4. Select the Z-Wave Protocol.

5. Make sure you can physically access your ZEN76 switch and click Start on the screen.

6. While the hub is in inclusion mode, tap the top paddle on the ZEN76 switch 3 times as quickly as possible. The LED indicator will start blinking. It may take a few minutes for the device to add and configure so please wait patiently and don't exit the screen.

* If you’re using an S2 hub, it will ask you to enter the DSK PIN or scan the QR code printed on the metal faceplate of the switch to complete SmartStart inclusion.

TROUBLESHOOTING:

If your switch is not found on the Z-Box Hub, you may need to reset it first. We recommend performing the reset using your hub and the exclusion option (it works even if the device has never been added to your hub before):

1. Open your Z-Box web interface in the Internet browser and select Settings (the gear icon) from the sidebar navigation menu. A list of your existing devices will appear.

2. Click the red - Remove device button in the top right corner.

3. Select Z-Wave Device in the next screen.

4. Make sure you can physically access your ZEN76 switch and click Start on the screen.

5. Tap the bottom paddle on the switch 3 times as quickly as possible. The LED indicator will start blinking and the Z-Box Hub will display a "Device removed" message.

If the LED indicator on the switch isn't blinking, make sure that the device turns on the light from the paddles. If it works well physically from the paddles, try a factory reset and then follow the inclusion steps above.

Questions? Just reach out to our support team and we'll guide you through the process!