How to Add Your ZEN32 Scene Controller to the Z-Box Hub

Add the Scene Controller to the Z-Box Hub and program the buttons as well as the on/off switch quickly and easily. Here is how to get started.

We encourage you to add Z-Wave devices to your hub from the WEB UI for the best experience but if you'd rather use the mobile app, we've included instructions for the process below as well.

ADD THE ZEN32 SCENE CONTROLLER FROM THE WEB UI:

1. Open your Z-Box web interface in the Internet browser and select Settings (the gear icon) from the sidebar navigation menu.

2. The screen will display all of your existing devices.

3. Click on the + Add device blue button in the top right corner.

4. Select Z-Wave Device in the next screen.

5. Make sure you can physically access your ZEN32 Scene Controller and click Start on the screen.

6. While the hub is in inclusion mode, tap the main button on the ZEN32 Scene Controller 3 times as quickly as possible. The LED indicators will start blinking. It may take a few minutes for the device to add and configure so please wait patiently and don't exit the screen.

7. Once the device is found, you'll be able to rename it and assign it to its room. The ZEN32 Scene Controller will create one device for the on/off operation of the main button switch and one remote control device for all of the buttons to program scene control. Buttons 1-4 are the 4 small remote control buttons on the device and button 5 is the main on/off switch button that can also be used for multi-tap triggers, whether it's physically connected to a load or not.

Click Next and then Finish once you rename and organize all of the newly created devices.

ADD THE ZEN32 SCENE CONTROLLER FROM THE Z-BOX MOBILE APP:

1. Open the Z-Box Hub app on your mobile device.

2. Click More in the bottom navigation menu.

3. Click on + Add Devices.

4. Select the Z-Wave Protocol.

5. Make sure you can physically access your ZEN32 Scene Controller and click Start on the screen.

7. Once the device is found, you'll be able to rename it and assign it to its room. The ZEN32 Scene Controller will create one device for the on/off operation of the main button switch and one remote control device for all of the buttons to program scene control from the WEB UI. Buttons 1-4 are the 4 small remote control buttons on the device and button 5 is the main on/off switch button that can also be used for multi-tap triggers, whether it's physically connected to a load or not. Click Next and then Finish once you rename and organize all of the newly created devices.

* If you’re using an S2 hub, it will ask you to enter the DSK PIN or scan the QR code printed on the metal faceplate of the switch to complete SmartStart inclusion.

TROUBLESHOOTING:

If your device is not found on the Z-Box Hub, you may need to reset it first. We recommend performing the reset using your hub and the exclusion option (it works even if the device has never been added to your hub before):

1. Open your Z-Box web interface in the Internet browser and select Settings (the gear icon) from the sidebar navigation menu. A list of your existing devices will appear.

2. Click the red - Remove device button in the top right corner.

3. Select Z-Wave Device in the next screen.

4. Make sure you can physically access your ZEN32 Scene Controller and click Start on the screen.

5. Tap the main button on the ZEN32 Scene Controller 3 times as quickly as possible. The LED indicators will start blinking and the Z-Box Hub will display a "Device removed" message.

If the LED indicators on the switch aren't blinking, make sure that the device turns on the light from the main switch to check if it's operational at all. If it works well physically from the switch button, try a factory reset and then follow the inclusion steps above.

Feel free to contact us if you run into any issues or have additional questions. Our team is here to help 7 days a week.