Accessing the advanced settings for the ZAC38 Range Extender on Hubitat is quick and easy. Just follow the steps below to install the community driver for the ZAC38 Range Extender:
Here's how to install the community driver:
-
Open Hubitat in your browser.
-
Click on Drivers Code in the side menu.
-
In the top right corner, click on "+New Driver" and paste the code from the following link to access the code for the driver, then copy ALL of the code from the page.
-
Click Save in the top right corner.
-
You'll see a Zooz ZAC38 Range Extender Advanced driver in your Drivers Code list now.
-
Assign the driver to the device by opening to the main (ZAC38) device view and selecting the Zooz ZAC38 Range Extender Advanced from the drop-down menu under Device Type.
-
Click Update Device.
-
IMPORTANT: Please go to the parent device and click configure and then wait for syncing to be completed. It will change to sync on the right upper side.
If you prefer not to use the custom driver, you can try out this Z-Wave Universal Device Scanner to access any parameters that may not be available yet in the custom driver. Please note that use of this driver is intended for expert users; use at your own risk: https://community.hubitat.com/t/release-z-wave-universal-device-scanner/97912
Let us know if you have any questions!
