You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
You are viewing the article in preview mode. It is not live at the moment.
Looking for Z-Box Hub Support? Please click here to access the Z-Box Hub Support Portal.
Home > Security Sensors & Sirens > ZSE44 Temperature | Humidity XS Sensor > ZSE44 & Z-Box Hub > My ZSE44 Temperature/Humidty Sensor Shows No Connection on My Z-Box Hub
My ZSE44 Temperature/Humidty Sensor Shows No Connection on My Z-Box Hub
print icon

My ZSE44 Temperature/Humidity Sensor Shows No Connection on My Z-Box Hub

Does your ZSE44 Temperature/Humidity Sensor display "No Connection" on your Z-Box Hub? Check out the troubleshooting steps below!

While a device may show as "No Connection" in a few cases, the Z-Box automatically refreshes the network and rebuilds the mesh on a regular basis in the background. Unlike most hubs currently available, there is no need for a command to refresh the network or repair the device connections on the Z-Box, as it is consistently running in the background and rerouting communication as necessary.

 

If your ZSE44 Temperature/Humidity Sensor is showing as "No Connection" on your Z-Box, start by clicking on the device tile to reconnect the device. Navigate to the Dashboard > click the red ZSE44 tile to ping the device. The ZSE44 should reconnect and return to green once connection is re-established.

 

Still showing "No Connection"?

  1. Adding a signal repeating (non-battery powered) device between the hub and the ZSE44 can help if range or interference are at play.

 

Try bringing the hub and device closer together, excluding the device and re-including it while near the hub. If the ZSE44 Temperature/Humidity Sensor is then included successfully and the connection remains steady, it is possible there is interference between the hub and the device, or the previous spot may be out of range.

 

If you are able to control your device from the Z-Box without issue but it is occasionally showing the device as "No Connection," you can disable the display by following the steps below:

 

  • Navigate to Settings > Devices > click on the arrow to open the settings for the ZSE44 > Advanced > Uncheck "Mark if Unavailable"
Feedback
0 out of 0 found this helpful

Have you tried our virtual assistant chatbot? This AI tool can help you find answers from thousands of articles in our Knowledge Base quickly. Find it in the bottom righthand corner of the page.

Need more help? Our friendly team is ready to help you with any questions or concerns you may have about Zooz devices. Click here to submit a support ticket.

Are your devices registered? Extended warranty and firmware access is available for registered Zooz customers. Click here to submit your registration form.

Find the latest Zooz devices and great Z-Wave deals at The Smartest House.
 
scroll to top icon