Once you've manually tested your ZEN34 Remote Switch, the next step is to integrate it into your HomeSeer network. By doing so, you'll be able to automate and remotely control the switch. Follow the steps below to quickly include your ZEN34 to HomeSeer.
Zooz products are officially integrated with the Z-Wave Plus and the Z-Wave JS Front-End of HomeSeer. If you're experiencing issues with accessing the advanced settings of your device or the unit not properly displaying, we would recommend first updating to the Z-Wave Plus or the Z-Wave JS Front-End, then excluding and re-including your device to your network in order for it to be recognized correctly.
You can use these steps to include the ZEN34 Remote Switch to HomeSeer:
- In the HomeSeer UI: open the "Devices" tab.
- Click + sign at the top right of the page;
- Select "Z-Wave".
- Click "Continue" to put the hub in inclusion mode.
- Tap the upper paddle 6 times quickly (LED indicator will start flashing)
- The LED indicator will blink blue during the process and light up green once it's been added successfully. Home Assistant should also confirm the inclusion directly in the interface. If you see the LED light up red, that means inclusion wasn't completed and you'll need to try it again.
- A window should then appear to allow you to select the supported security level; if S2A is selected, a new window will appear for pin entry.
- Follow the prompts to assign the device to a specific room/area and rename it.
- Double check the information and finalize inclusion by clicking "Continue"
If you encounter any issues including your switch to HomeSeer, try excluding it first. The process can be done even if the switch was never included and acts as a type of soft Z-Wave reset that generally resolves most inclusion issues.
Feel free to send us a message if you need help troubleshooting the device!
