Let's get the ZEN37 Wall Remote integrate it into your HomeSeer network. By doing so, you'll be able to automate and remotely control the switch. Follow the steps below to quickly include your ZEN37 to HomeSeer.
Zooz products are officially integrated with the Z-Wave Plus and the Z-Wave JS Front-End of HomeSeer. If you're experiencing issues with accessing the advanced settings of your device or the unit not properly displaying, we would recommend first updating to the Z-Wave Plus or the Z-Wave JS Front-End, then excluding and re-including your device to your network in order for it to be recognized correctly.
You can use these steps to include the ZEN37 Wall Remote to HomeSeer:
- In the HomeSeer UI: open the "Devices" tab.
- Click + sign at the top right of the page;
- Select "Z-Wave".
- Click "Continue" to put the hub in inclusion mode.
- Click the top button 6 times quickly.
- The LED indicator will blink blue during the process and light up green once added successfully. It will light up red if failed.
- A window should then appear to allow you to select the supported security level; if S2A is selected, a new window will appear for pin entry.
- Follow the prompts to assign the device to a specific room/area and rename it.
- Double check the information and finalize inclusion by clicking "Continue"
If you encounter any issues including your switch to HomeSeer, try excluding it first. The process can be done even if the switch was never included and acts as a type of soft Z-Wave reset that generally resolves most inclusion issues.
Feel free to send us a message if you need help troubleshooting the device!
