This is product is discontinued and replaced with ZSE70.

What does that mean?

If you find that your motion sensor isn't working well on Vera since it was recognized as a Generic Z-Wave Device, you'll need to manually configure the motion part of the sensor. 

Here's how to do it: 

1. In the Vera online (browser) interface, select the sensor, then click on Advanced.
2. Go to the Params tab and make the following changes: 

• device_type: urn:schemas-micasaverde-com:device:MotionSensor:1
• device_file: D_MotionSensor1.xml
• device_json: D_MotionSensor1.json
• Category: 4
• SubCategory: 3

Then activate the sensor by clicking the tamper switch next to the battery compartment 3 times quickly (just like during inclusion). After that, leave the device by your Vera for a few hours so it can fully configure.

If it so happens that the motion sensor disappears from the dashboard, you may need to reload engine. Simply go to Settings -> Z-Wave Settings -> Advanced Tab and click on Reload Engine. That should help the configuration.

If you're still experiencing issues with the device or have any questions about the process, let our team know!