We recommend using the community driver linked below for the best access to all of the advanced settings for the ZEN17.
You'll want to confirm your Hubitat hub is on the latest platform version and that your ZEN17 has the most recent firmware update. You'll be able to see all of the available settings under Preferences of the primary device in Hubitat (remember to save the device after each change).
Follow the instructions below to install the custom driver:
-
Open Hubitat in your browser.
-
Click on Drivers Code in the side menu.
-
In the top right corner, click on "+New Driver" and paste the code from the following link to access the code for the driver, then copy ALL of the code from the page.
-
Click Save in the top right corner.
-
You'll see a Zooz ZEN17 Universal Relay in your Drivers Code list now.
- Assign the driver to the device by opening to the device view and selecting the Zooz ZEN17 Universal Relay from the drop-down menu under Type* > User (scroll all the way down).
-
Click Update Device.
-
You will now see the additional setting display in the device view in Hubitat where you can customize the device.
-
Once done, click Update Device again.
-
IMPORTANT: Please go to the parent device and click configure and then wait for syncing to be completed. It will change to sync on the right upper side.
If you prefer not to use the custom driver, you can try out this Z-Wave Universal Device Scanner to access any parameters that may not be available yet in the custom driver. Please note that use of this driver is intended for expert users; use at your own risk: https://community.hubitat.com/t/release-z-wave-universal-device-scanner/97912
Let us know if you have any questions!
