This is product is discontinued and replaced with ZSE11.
Here are the features we added to the 4-in-1 Sensor so far.
VER. 1.0 (released 9/2016)
Hardware:
- 2 x AAA batteries
- Mounting bracket included
- 500 Series Z-Wave chip
Firmware: 16.09
-
4 LED indicator modes
-
12h wake-up interval
VER. 1.0 (released 8/2017)
Hardware:
- Decreased LED indicator brightness
Firmware: 17.09
-
Added unsolicited battery reports every 12 h
-
Changed the default value for parameter 6 (motion sensitivity) from 4 to 3 (see all settings here)
-
Changed the default value for parameter 7 (LED indicator mode) to 4 (flash on motion detection only)
VER. 2.0 (released 8/2018)
Hardware:
- Changed battery type to 1 x CR123A battery
Firmware: 24.16
-
Changed the motion retrigger range from 15-60 s to 15-255 s.
VER. 2.0 (released 2/2020)
Firmware: 32.02
-
Added Association Group 2 with basic set reports only
-
Added parameter 8 to disable basic set reports sent to Association Group 1 (see all settings here)
VER. 2.0 (released 10/2020)
Firmware: 32.12
-
Removed motion reports sent to the hub every 8 seconds when motion was active
ZSE40 700 (released 6/2021)
Hardware:
- 700 Series Z-Wave Chip: better range and longer battery life
Firmware: 32.32
-
Based on firmware 32.02 from the 500 series model
ZSE40 700 (released 3/2022)
Firmware: 1.10
-
Firmware version changed to 1.10 to follow new naming convention for device firmware files
-
Added parameters 9 and 10 for temperature and humidity offset settings (see all settings here)
Your 4-in-1 Sensor 700 series can be updated via OTA firmware updates but most of the 500 series model also underwent hardware changes that make it impossible to update to a newer version. Please check your model and version carefully before updating it. You can access all firmware files here after you register your product and create an account here. Questions? Just reach out to our tech support team.
