If you are having difficulty including your ZEN53 DC Motor Controller to Home Assistant, the best place to start is exclusion! The device can be excluded from Home Assistant even if it has never been successfully included. Exclusion is a simple process that acts like a hub-based reset that helps with any configuration or connectivity issues.
Follow the steps below to exclude the ZEN53:
Important Note: A steady, blinking green is the standard state for the device; as long as the unit has power, it will blink green at a steady pace. The device has an internal relay, which can turn on and off with a click of the Z-Wave button. This means that when you are attempting to include or exclude the device, the clicks need to happen as fast as possible; if the clicks are not completed fast enough, the relay will engage instead and the device will not enter inclusion or exclusion mode. You will know you have clicked fast enough when the LED indicator begins flashing rapidly.
- In Home Assistant: open Settings > Devices and Services > Z-Wave JS > Configure
- Click on Remove Device
- Click on Start Exclusion
- Click the Z-Wave button 3 times as quickly as possible (the LED indicator will start flashing)
- Home Assistant will confirm that the device was removed, and you should now be able to add it to your system
Once Home Assistant confirms a successful exclusion, please try including the device once more:
- Ensure the unit is installed and powered by the correct 6-32 VDC power supply
- In Home Assistant: click on Add a Z-Wave Device
- When Home Assistant displays the following message: "Your Z-Wave controller is now in inclusion mode. Follow the directions that came with your device to trigger pairing on the device," click the Z-Wave button 3 times as quickly as possible (the LED indicator will start flashing)
- If asked to enter the SmartStart security PIN, enter the PIN located on the back of the device, next to the Z-Wave Plus logo
- The LED indicator will blink green to signal communication, and turn green for 2 seconds if inclusion is successful
- Home Assistant will confirm that the device was added, and it will be immediately visible in your device list
Please reach out to us if you have any questions!
