Once you have the ZEN55 correctly installed and powered, you can include the device to your Z-Wave hub. Inclusion is another name for adding the device to your Z-Wave hub. Simply follow the steps below to have the ZEN55 included in no time!
Important Note: A steady, blinking green is the standard state for the device; as long as the unit has power, it will blink green at a steady pace. The device has an internal relay, which can turn on and off with a click of the Z-Wave button. This means that when you are attempting to include or exclude the device, the clicks need to happen as fast as possible; if the clicks are not completed fast enough, the relay will engage instead and the device will not enter inclusion or exclusion mode. You will know you have clicked fast enough when the LED indicator begins flashing rapidly.
To auto-include your ZEN55 Smoke & CO Detector Bridge:
- Put your Z-Wave hub into inclusion/pairing mode (see your hub's manual for instructions since each brand is different). If you’re using an S2 hub, it may ask you to enter the DSK key printed on the back cover sticker to complete secure inclusion
- The LED indicator will blink green to signal communication and turn green for 2 seconds if inclusion is successful.
To manually include your ZEN55 Smoke & CO Detector Bridge:
- Put the Z-Wave hub into inclusion/pairing mode (see your hub's manual for instructions since each brand is different)
- Click the Z-Wave button 3 times quickly.
- The LED indicator will blink green to signal communication and turn green for 2 seconds if inclusion is successful.
- The new device should appear on your hub's device list
If you've tried auto and manual inclusion but you're still unable to include the ZEN55 DC Signal Sensor, please start by excluding the device, then try inclusion again.
Please let us know if you have any questions. We're always happy to help!
