Device didn't configure fully during inclusion? Hub shows a pending change? You may need to wake your sensor manually!

Battery powered devices are normally sleeping, to conserve battery. If you've made a change to the advanced settings for the ZSE42 Leak Sensor, the change will take effect once the device wakes up to receive communication from the hub. The sensor’s wake-up interval is set to 12 hours by default to save battery life.

To manually wake the ZSE42 Water Leak Sensor:

• Click the Z-Wave button 4 times quickly to wake the sensor up manually.
• The LED indicator will flash once to confirm the device is awake. During wake-up, the sensor turns the Z-Wave radio on for one minute to receive communication from the hub. Long wake-up interval will not affect how often the sensor reports to your hub so we recommend leaving the default setting to conserve battery.

Please don't hesitate to reach out to us with any questions!