Is the ZEN37 Wall Remote displaying "No Connection" on your Z-Box Hub? Check out the simple troubleshooting steps below!

While a device may show as "No Connection" in a few cases, the Z-Box automatically refreshes the network and rebuilds the mesh on a regular basis in the background. Unlike most hubs currently available, there is no need for a command to refresh the network or repair the device connections on the Z-Box, as it is consistently running in the background and rerouting communication as necessary.

If your ZEN37 Wall Remote is showing as "No Connection" on your Z-Box, start by clicking on the device tile to reconnect the device.

• Navigate to the Dashboard > click the red ZEN37 tile to ping the device. The ZEN37 should reconnect and return to green once connection is re-established.

Still showing "No Connection"?

• Adding a signal repeating (non-battery powered) device between the hub and the ZEN37 can help if range or interference are at play.

Try bringing the hub and device closer together, excluding the device and re-including it while near the hub. If the ZEN37 Wall Remote is then included and the connection remains steady, it is possible there is interference between the hub and the device, or the previous spot may be out of range.

If you are able to control your device from the Z-Box without issue but it is occasionally showing the device as "No Connection," you can disable the display by following the steps below:

• Navigate to Settings > Devices > click on the arrow to open the settings for the ZEN37 > Advanced > Uncheck "Mark if Unavailable"

Questions? Please don't hesitate to reach out to us at any time; we're always happy to help!