There is No LED Activity and My ZEN55 Smoke and Co Detector Bridge is Unresponsive

Looking for Z-Box Hub Support? Please click here to access the Z-Box Hub Support Portal.

Home > Security Sensors & Sirens > ZEN55 Smoke & CO Detector Bridge > ZEN55 & Your Z-Wave System > There is No LED Activity and My ZEN55 Smoke and Co Detector Bridge is Unresponsive

Is the ZEN55 Smoke and Co Detector Bridge installed, but there is no LED activity, and the relay is unresponsive? Please check out the list of troubleshooting steps below.

First, check that you have restored power to the unit at the breaker panel, following the completion of the installation.

Ensure the device is connected to an electric power source that does not exceed the maximum load power.

CHECK THE WIRES: ensure the device is wired exactly like the diagram, and don't rely exclusively on your multimeter to identify the wires:

Have you verified everything listed above is correct? Please get in touch, we are happy to help!

Feedback

0 out of 0 found this helpful

Need additional information

Hard to understand

Inaccurate/irrelevant content

Missing/broken link

Have you tried our virtual assistant chatbot? This AI tool can help you find answers from thousands of articles in our Knowledge Base quickly. Find it in the bottom righthand corner of the page.

Need more help? Our friendly team is ready to help you with any questions or concerns you may have about Zooz devices. Click here to submit a support ticket.

Are your devices registered? Extended warranty and firmware access is available for registered Zooz customers. Click here to submit your registration form.

Find the latest Zooz devices and great Z-Wave deals at The Smartest House.