This is product is discontinued and replaced with the ZEN73. What does that mean?

If you're having issues including your switch to Home Assistant, exclusion is the first thing to try; exclusion is like a soft reset: 

A device doesn't need to be included first to be able to excluded. Here's how to do it: 

1. In Home Assistant: open Settings > Devices and Services > Z-Wave JS > Configure
2. Click on Remove Device
3. Click on Start Exclusion
4. Toggle the switch DOWN 3 times very quickly to finalize the exclusion process
5. The device will now be removed, but that won’t show until you restart Home Assistant
6. Run a Heal Network so all the other nodes learn about its removal

After exclusion is confirmed, try adding the device back to Home Assistant again. 

If that didn't work, here are some troubleshoots we find helpful: 

• Try the exclusion process again! It's possible the exclusion commands from the first run weren't registered correctly. 
• Try the inclusion process once more,  this time toggling the switch UP 6-7 times as quickly as possible. This can help make sure the commands go through.
• If you have a Z-Wave signal repeater available (switch, relay, smart plug, dedicated repeater - any Z-Wave device that doesn't rely on battery power), we'd recommend moving it between the switch and hub and then healing the network. This can help in case there is an interference or range issue preventing stable communication between the two nodes. 
• If possible, try bringing the hub within direct range of the switch if you were at a large distance the first time. If you have a hand-held secondary controller, this would be the time to bring it out!
• And if you find that your switch is connected but it's not responded to remote commands, try these tips for troubleshooting connectivity issues. 

If you've tried all the above with no luck, let us know! Our team is ready to help.