Include your ZSE42 and have it recognized right out of the box!
If the settings are not showing up for you right away, you'll want to confirm your Hubitat hub is on the latest platform version (2.2.9 or higher). Just look under Preferences in the device view to customize your sensor.
All About Advanced Settings
The terminology for advanced settings varies depending on your Z-Wave hub. For instance, Hubitat lists them under the “Preferences” tab. Despite these differences in naming, the purpose remains the same: configuring consistent behavior for your device. We provide the full list of settings available for each device in our Knowledge Base.
Each advanced setting consists of four key parts:
-
Label: If your device is properly integrated with your hub, this will display as the setting's name. Hubs like SmartThings show only the label and description.
-
Parameter Number & Description: Most hubs, such as Hubitat and Home Assistant, list the parameter number along with the label and description.
-
Values: These are the selectable options for each setting. Some are simple (e.g., Enable/Disable), while others use numerical values.
-
Size: This is required in some systems when manually changing advanced settings (e.g., Home Assistant) or in hubs that do not provide direct access to settings.
If you find there are settings you are unable to access, or if you would like to use the community driver, check out the instructions below!
Install the Community Driver
If you'd like to adjust a setting that isn't exposed in the built-in driver, you can try using the custom driver to customize your XS Water Leak Sensor.
Here are the steps for using the custom driver:
-
Open Hubitat in your browser.
-
Click on Drivers Code in the side menu.
-
In the top right corner, click on "+New Driver" and paste the code from the following link to access the code for the driver, then copy ALL of the code from the page.
-
Click Save in the top right corner.
-
You'll see a Zooz ZSE42 WATER LEAK XS SENSOR in your Drivers Code list now.
-
Assign the driver to the device by opening to the device view and selecting the Zooz ZSE42 WATER LEAK XS SENSOR from the drop-down menu under Device Type.
-
Click Update Device.
- IMPORTANT: Click the CONFIGURE button in the interface for all of the settings to appear and wake the device up by clicking the Z-Wave button 4 times quickly so it can fully configure. You may need to refresh the Hubitat page in your Internet browser as well.
-
You will now see the additional setting display in the device view in Hubitat where you can customize the sensor.
-
Once done with any settings changes, click Update Device again and manually wake the sensor to receive the changes.
Here is the full list of settings for the XS Water Leak Sensor.
If you prefer not to use the custom driver, you can try out this Z-Wave Universal Device Scanner to access any parameters that may not be available yet in the custom driver. Please note that use of this driver is intended for expert users; use at your own risk: https://community.hubitat.com/t/release-z-wave-universal-device-scanner/97912
Let us know if you have any questions!