If you find the inclusion process isn’t working for your ZSE70, then it’s time to try excluding it.

While it might seem like an odd step to take, this process actually acts as a soft reset to help with any inclusion or configuration problems. You’ll be able to do this even if the ZSE70 was never added to Hubitat. You’ll want to confirm your Hubitat platform has the latest version installed first. Once you’ve done that, you can use the steps below to exclude.

ZSE70 Exclusion Steps

1. Open Hubitat in your Internet browser

2. Go to Devices

3. Click on + Add Device in the top right corner

4. Click on Z-Wave

5. Click on Start Z-Wave Exclusion

6. While the device is searching for a device, click the Z-Wave button on the device 3 times as quickly as possible

7. The app will indicate when the device is successfully excluded.

After completing the exclusion process, you should then be able to include your ZSE70 to Hubitat using these steps. If exclusion does not allow for inclusion, please factory reset the device.

SmartStart and Z-Wave Long Range Inclusion Troubleshooting

If exclusion is not successful, if you have previously added this device to your hub, if SmartStart failed, or if the device will not include, please follow the steps below in order. Removing the device from the provisioning list generally resolves most inclusion issues:

Removal of a Z-Wave Plus SmartStart device is a two step process. First remove the device from the app, then factory reset it.

1. Using the Hubitat Elevation mobile app, navigate to Tools and press the Z-Wave Tools card

2. Tap the SmartStart button > Tap the trash can icon to remove a device from the provisioning list. Removing an item from the SmartStart provisioning list does not remove it from the hub. You must also factory reset it, so it will no longer be part of the Z-Wave network. 

   • NOTE: Any device that has been removed from the provisioning list, but has not been factory reset or excluded from the Z-Wave network, will be automatically included again if it has power, and it will repopulate the provisioning list showing the Included status.

  3. The device has now been removed from the provisioning list.

  4. Factory reset the ZSE70. After a successful reset, the device will disappear from the device list.

  5. Remove power from the ZSE70 if you plan to include the unit via SmartStart / Z-Wave Long Range. 

  6. Go through the inclusion steps listed here to include the device (remember, power stays OFF until indicated).

Additional Troubleshooting

• Try the exclusion process again in case the command from the first run weren't registered correctly. 

• Try bringing the hub closer to the device to see if it connects in a closer location. If it connects without issue in the new spot, then the first location may be out of range or there may be too many interferences in that area.

• And if you find that your device is connected but it's not responded to remote commands, check out these tips for troubleshooting connectivity. 

If you've tried all the above with no luck, let us know! Our team is ready to help.