If you're having trouble adding your ZEN73 On/Off Switch to HomeSeer, exclusion is the first thing to try.
The exclusion process acts as a soft reset and can be done even if you haven't paired the ZEN73 to HomeSeer or another Z-Wave network before. However, please note that exclusion before inclusion applies to the 700 series and earlier chip sets. The 800 series devices will not exclude before they have been included; please factory reset the unit instead, then try inclusion again.
Zooz products are officially integrated with the Z-Wave Plus and the Z-Wave JS Front-End of HomeSeer. If you're experiencing issues with accessing the advanced settings of your device or the unit not properly displaying, we would recommend first updating to the Z-Wave Plus or the Z-Wave JS Front-End, then excluding and re-including your device to your network in order for it to be recognized correctly.
Here are the steps for excluding the ZEN73 Switch in HomeSeer:
- In the HomeSeer UI, click the "Plugins;" from the drop-down menu, select "Z-Wave."
- Select "Remove Device."
- You will be taken to a new page; click "Continue" to start the exclusion process on the hub.
- Toggle the switch DOWN 3 times very quickly (LED indicator will start flashing)
- HomeSeer should confirm the device was removed. Finalize by clicking "Finish."
Once the exclusion process is successfully finalized, try including the device to HomeSeer.
Here are some additional troubleshoots if the above did not help:
- Give the exclusion process another try! It's possible the command from the first run wasn't registered correctly.
- When excluding more than once, and not receiving confirmation it was removed, try tapping the lower paddle 4-5 times quickly. This can help make sure the commands go through.
- If you have a Z-Wave signal repeater available (switch, relay, smart plug, dedicated repeater - any Z-Wave device that doesn't rely on battery power), try placing it between the switch and hub. Make sure to heal the network so that the hub recognizes the new device. This can help in case there is an interference or range issue preventing stable communication between the two nodes.
- Try bringing the hub within direct range of the switch if the switch is located far away from the hub. If you have a hand-held secondary controller, this would be the time to bring it out!
- If your switch has successfully connected but it's not responding to Z-Wave commands, check out these tips for troubleshooting connectivity.
Reach out to us if you're still experiencing issues! Our team is ready to help.
