You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
You are viewing the article in preview mode. It is not live at the moment.
Looking for Z-Box Hub Support? Please click here to access the Z-Box Hub Support Portal.
Home > Smart Relays > ZEN17 Universal Relay > ZEN17 & HomeSeer > Can't Add My ZEN17 Universal Relay to HomeSeer
Can't Add My ZEN17 Universal Relay to HomeSeer
print icon

If you're having trouble adding your ZEN17 Universal Relay to HomeSeer, you may need to try exclusion first.

Zooz products are officially integrated with the Z-Wave Plus and the Z-Wave JS Front-End of HomeSeer. If you're experiencing issues with accessing the advanced settings of your device or the unit not properly displaying, we would recommend first updating to the Z-Wave Plus or the Z-Wave JS Front-End, then excluding and re-including your device to your network in order for it to be recognized correctly.

 

The exclusion process acts as a soft reset and can be done even if you haven't paired the ZEN17 to HomeSeer or another Z-Wave network before. Here are the steps for excluding the ZEN17 Universal Relay in HomeSeer: 

 

  1. In the HomeSeer UI, click the "Plugins;" from the drop-down menu, select "Z-Wave."
  2. Select "Remove Device."
  3. You will be taken to a new page; click "Continue" to start the exclusion process on the hub.
  4. Click the Z-Wave button 3 times as quickly as possible (the LED indicator will start flashing).
  5. HomeSeer should confirm the device was removed. Finalize by clicking "Finish."

Once the exclusion process is successfully finalized, try including the device to HomeSeer. 

 

Here are some additional troubleshoots if the above did not help: 

  • Give the exclusion process another try! It's possible the command from the first run wasn't registered correctly. 
  • When excluding more than once, and not receiving confirmation it was removed, try clicking the Z-Wave button 4-5 times quickly. This can help make sure the commands go through.
  • If you have a Z-Wave signal repeater available (switch, relay, smart plug, dedicated repeater - any Z-Wave device that doesn't rely on battery power), try placing it between the switch and hub. Make sure to heal the network so that the hub recognizes the new device. This can help in case there is an interference or range issue preventing stable communication between the two nodes. 
  • Try bringing the device within direct range of the hub and excluding and including the unit from there. If it includes successfully, the desired target location may be too far from the hub.

Reach out to us if you're still experiencing issues! Our team is ready to help. 

Feedback
0 out of 0 found this helpful

Have you tried our virtual assistant chatbot? This AI tool can help you find answers from thousands of articles in our Knowledge Base quickly. Find it in the bottom righthand corner of the page.

Need more help? Our friendly team is ready to help you with any questions or concerns you may have about Zooz devices. Click here to submit a support ticket.

Are your devices registered? Extended warranty and firmware access is available for registered Zooz customers. Click here to submit your registration form.

Find the latest Zooz devices and great Z-Wave deals at The Smartest House.
 
scroll to top icon