It might seem counter-intuitive, but if you're having trouble adding your ZEN15 Power Switch to HomeSeer, you may need to try exclusion first. Any Z-Wave device can be excluded from any Z-Wave hub at any time, regardless if it has been included to the current hub or not.

The exclusion process acts as a soft reset and can be done even if you haven't paired the ZEN15 Power Switch to HomeSeer or another Z-Wave network before. Here are the steps for excluding the ZEN15 from HomeSeer: 

1. In the HomeSeer UI, click the "Plugins;" from the drop-down menu, select "Z-Wave."
2. Select "Remove Device."
3. You will be taken to a new page; click "Continue" to start the exclusion process on the hub.
4. Click the Z-Wave button on the ZEN15 3 times very quickly (the LED indicator will start flashing).
5. HomeSeer should confirm the device was removed. Finalize by clicking "Finish."

Once the exclusion process is successfully finalized, try including it back to HomeSeer.

Here are some additional troubleshoots if the above did not help: 

• Give the exclusion process another try! It's possible the command from the first run wasn't registered correctly. 
• When excluding more than once, and not receiving confirmation it was removed, try tapping the Z-Wave button 4-5 times quickly. This can help make sure the commands go through.
• Try bringing the device within direct range of the hub and excluding and including the plug from that location. If the device excludes/includes without issue, the target location may be out of range. 

 Reach out to us if you're still experiencing issues! Our team is here to help.