On/off status not displaying properly, scenes failing to run or reports not being received? This can point to a connectivity issue between the ZEN15 and your HomeSeer hub. Check out the troubleshooting steps below if your ZEN15 is unavailable, shows as offline, or is unresponsive to commands via HomeSeer.
When connected to the hub through the standard Z-Wave mesh, the ZEN15 Power Switch has a range of up to 300 feet line of sight (or up to 1 mile with Long Range enabled). However, interference from large furniture, thick walls, and metal elements can reduce this range. The actual range depends on your home's specific structure and the strength of your mesh network. If you experience connectivity issues, we recommend first healing your HomeSeer network, also known as rebuilding routes. This function refreshes the connections between your hub and devices, allowing the hub to find the most efficient route to each device.
Rebuilding Routes
-
Click on the on the upper left hand side of the interface.Plugins drop-down menu
-
Click on . Z-Wave Plus
-
Select .Advanced Functions
-
From the first drop down menu, select the name of the Z-wave network you are repairing/rebuilding routes.
-
From the second drop down menu, select Rebuild All Routes.
-
Click The network repair will occur; remember to manually wake any battery powered devices to complete the rebuild.Continue.
Additional Troubleshooting Steps
-
Try excluding and including the plug directly from its target location. It could be that the hub hasn't found the most efficient communication route to the plug and excluding it will help the hub devise a better route of communication to the ZEN15.
-
Add a Z-Wave signal repeater in a location between the plug and hub. This can be any Z-Wave device that doesn't rely on battery power. If the issue is caused by interference or range, a signal repeater can help strengthen and stabilize connectivity. After adding the repeater, it's a good idea to rebuild routes once more.
-
Bring the ZEN15 closer to the hub, removing and re-adding the plug in the new spot. If the ZEN15 includes successfully, stays connected, and is responsive to remote commands, it's possible the previous location was out of the hub's range or there is too much interference in that particular area.
If none of the above troubleshooting steps solve the problem, please let us know! We're always here to help!
