The ZSE11 Q Sensor can be powered by 2 CR 123A batteries (included) OR a micro-USB cable (sold separately). The sensor can only be powered by a single power source. If it's powered by both USB and battery, it may damage it and it could not work on battery reliably afterwards. Once the batteries or USB cable are…
Is the ZEN51 Dry Contact Relay installed, but there is no LED activity, and the relay is unresponsive? Please check the list below. * First, check that you have restored power to the unit at the breaker panel, following the completion of the installation. * Ensure the device is connected to an electric power s…
The ZSE43 Tilt | Shock Sensor's LED indicator should flash once the battery tab is removed from the device for around 10 seconds, or any time you press the Z-Wave button. Are you not seeing the LED indicator flash, or is the device unresponsive to commands? To start, please ensure the battery is inserted correctly…
Once the battery tab is removed, the ZSE44 Temperature | Humidity Sensor's LED indicator should flash for around 10 seconds or any time you press the Z-Wave button. Does the LED indicator fail to flash, or is the device unresponsive? First, make sure the battery is inserted correctly per the positive / negative po…
You've connected the ZEN17 Universal Relay to a power source, but the LED indicator isn't lighting up. Start by verifying that the USB cable is compatible with the Universal Relay. Do not use laptop or tablet chargers with the ZEN17, as these devices expect a larger load, and will not activate with the ZEN17. …
If the battery tab has been removed from the device, the LED indicator for the ZSE42 Water Leak Sensor should flash for around 10 seconds, or whenever the Z-Wave button is clicked. Is the sensor unresponsive and the LED is not flashing? To begin, double check that the battery is inserted in the sensor correctly, a…
The LED indicator for the ZSE41 Open | Close Sensor should flash for around 10 seconds once the battery tab has been removed from the device. Does the LED not flash? Is the ZSE41 unresponsive to commands? Try the steps below to resolve the issue. First, double check that the battery is inserted in the sensor corre…
Make sure the battery tabs have been removed in order to power your Remote Switch. You'll want to use the included triangle tool to gently open the remote and access the batteries. If you remove the battery tabs and see no LED activity whatsoever, make sure the batteries are oriented properly. If you find the rem…
By default, the LED indicators on the ZEN32 buttons will be off when they are on, and on when the buttons are off. If you're not seeing the LEDs light up at all, but still able to control any load that is connected to the relay or programmed to the buttons, then it's possible you'll need to change some settings. …
By default, the LED indicators for both the dimmer and relay should turn off when the switch is on and on when the switch is off. First thing's first: try manually activating the LED indicator mode. This is a new feature that allows you to manually change the LED mode without go through advanced settings, so it's po…